全国服务热线
15552522412?
联系我们
亿电竞平台app

联系人:田经理

联系电话:15552522412?

网址:

地址:济南市天桥区北园大街248号二楼西侧间

卫生间下水道改造的要求!

来源:  发布时间:2021-01-21 13:42:11

新房装修总会遇到卫生间的管道改造,对于卫生间下水道的改装,在开始的时候就应该多加注意,防止改造错误对之后的使用产生影响,那么卫生间下水道改造有哪些要求呢?下面小编给大家介绍下。
New house decoration will always encounter the transformation of the toilet pipe, for the transformation of the toilet sewer, at the beginning should pay more attention to prevent the transformation error after the use of the impact, so what are the requirements of the transformation of the toilet sewer? Let's introduce it to you.
1、卫生间下水道改造一般走顶不走地,冷、热水出水口要水平,一般左热右凉,管道铺设需横平坚直。管道布局走向要安全合理,管卡位置和管道坡度要符合相关规范要求。
1. Toilet sewer transformation generally goes to the top but not to the ground, cold and hot water outlets should be horizontal, generally left hot and right cool, and pipeline laying should be horizontal and straight. The pipeline layout shall be safe and reasonable, and the pipe clamp position and pipeline gradient shall meet the requirements of relevant specifications.
2、进水应设有室内总阀,安装前要检查水管及连接配件是否有破损、砂眼、裂纹等现象。水表安装位置应方便读数和维修。
2. The water inlet should be equipped with indoor main valve. Before installation, check whether the water pipe and connecting fittings are damaged, sand holes, cracks, etc. The installation position of water meter shall be convenient for reading and maintenance.
3、冷、热水管都应当入墙安装,开槽时需检查槽的深度,冷热水管不能同槽。
3. Cold and hot water pipes should be installed into the wall. The depth of the groove should be checked when slotting. Cold and hot water pipes should not be in the same groove.
4、坐便器的进水出口尽量安置在能被坐便器挡住视线的地方。连体坐便器要根据型号来确定出水口的位置,一般要留在马桶下水口正中左方200 mm处。
4. The water inlet and outlet of the toilet should be placed as far as possible where the sight can be blocked by the toilet. The position of the water outlet should be determined according to the model of the connected toilet, which should be left 200 mm to the left of the center of the toilet outlet.
                                            亿电竞平台app
5、安装热水器进出水口时,进水的阀门和进气的阀门一定要考虑并应安装在相应的位置。
5. When installing the water heater inlet and outlet, the inlet valve and inlet valve must be considered and installed in the corresponding position.
6、墙体内、地面下,尽可能少用或不用连接配件,以减少渗漏隐患点。连接配件的安装要保证牢固、无渗漏。
6. In the wall, under the ground, as far as possible with or without connecting accessories, in order to reduce the leakage potential points. The installation of connecting accessories shall be firm and free from leakage.
7、墙面上给水预留口的高度要适当,既要方便维修,又要尽可能少让软管暴露在外,并且不另加接软管,给人以简洁、美观的视觉。
7. The height of the water supply reserved opening on the wall should be appropriate. It should be convenient for maintenance, and the hose should be exposed as little as possible, and no additional hose should be connected, so as to give people a concise and beautiful vision.
8、卫生间下水道改造完成要做管道压力实验,实验压力不应该小于0.6MPa。时间为20-30分钟。
8. Pipeline pressure test should be done after the renovation of toilet sewer, and the test pressure should not be less than 0.6MPa. The time is 20-30 minutes.
XML 地图 | Sitemap 地图